The excrement scraper is suitable for the closed ground livestock house. This can be flat floor, every fixed distance there is a cesspit, but it can also be a sloping ground, so that the feces tilt inward to move, and the combined scraper with plastic wear strips can make the effect clean.

  Without building adjustment, V-type manure scraper can be installed in every livestock house quickly and simply. The whole equipment is installed on the flat floor, so the cost of livestock building is greatly reduced. This set of equipment is also suitable for livestock houses with different lengths of dung passages.

  Scraping board is the main part of the automatic scraping machine. Since the appearance of the automatic scraping machine, it has been accepted by the vast number of breeding places at a very open speed. Nowadays, both large and small farms are equipped with automatic manure scraper. However, many people just know how to use the automatic manure scraper, and will not use it correctly. So, what is the significance of the practical equipment for scraping manure?

Here's how to use the automatic manure scraper correctly:

1. First, check whether the power contact of the automatic manure scraper is normal and whether the socket is loose.

2. Check whether the tightness of the bolts of each part of the automatic manure scraper is very tight, because the bolts can not be loosened, so whether the two ends of the manure cleaning belt are right is also a direction of inspection.

3. After the inspection of each part, start the machine and start the operation with the automatic fecal scraper facing the place where feces are accumulated.

4. In the process of work, it should be noted that the horizontal type of automatic manure scraper should be started first, and then the vertical type of automatic manure scraper can be started. After a period of work, the machine can be allowed to have a little rest, and the temperature of the motor can be cooled down, which can protect the life of the automatic manure scraper.

5. When turning off the automatic manure scraper, first turn off the manufacturer of the vertical automatic manure scraper, and then turn off the horizontal automatic manure scraper. Do not make mistakes in the sequence.

6. After the machine is shut down, clean the machine, and then pour the lubricating oil into the oil filling hole, and place it in a dry place where there is no rain.

Operation principle of manure scraper:

1. The scraping machine is composed of two main scraping plates and two side scraping plates, and an index device is arranged in the middle.

2. When the main manure scraper is pulled forward by the chain, the side plates on both sides will open to contact the edge of the cattle bed, which can push the manure into the manure tank.

3. When it runs in the opposite direction, the manure remover will be in no-load state, the side plate will fold inward, and the main scraper will dump in the opposite direction.

4. When the scraping machine returns to the starting position, the flank is opened again and the next process of defecation is started.