Although the current pig farm construction is using full-automatic mechanical equipment, but there will be many details, such as how to use the equipment, precautions, how to install the problem. If we let the factory arrange people to install, it will increase the cost for the farmers invisibly. We can find some amateur installers, but we don't trust them. These problems have been bothering the farmers. Let's talk about how to install them.

  First of all, from the perspective of the most basic manure scraper, since it was put into use in the pig farm, it has been praised by the farmers for a time and saved a lot of expenses. Although it is welcomed by the majority of pig farmers, there are many problems in the installation.

  First of all, we fix the angle wheel on the bottom surface, and make sure that it is parallel. Put the scraper into the dung channel, and wrap the rope around the rope wheel on the main engine. When winding the rope, if it is wound in from the top, then the exit must come out from the top. (it is recommended to wrap it over from the top). Make sure to reserve a length of rope and wrap it around the scraper On the top of the lever. After that, start winding the rope around the corner wheel and the scraping board. At this time, remember not to tighten the rope on the scraping board. After winding the rope, fasten the end of the rope. Then start the motor and tighten the rope. Put the rope reserved before at the beginning of the scraping board. If you still feel that the rope is loose, the scraping board is equipped with a rope tightener, which can tighten the rope Hold on. Finally, tighten the rope to the scraper.

  The above is the process of installing the manure scraper. The general process is to wrap the traction rope - fix the castor - install the manure scraper - tighten the traction rope.

  If you have any questions about the installation, please leave a message in the website!